DunneFamilyStrawBale

Unless the Lord build the house......

Well I decided it was time to do that last project of extending 

a porch on our rustic log shed so that we can clean out the 

lumber from around the house porches. 

This is so we can begin the first layer of plaster. 

Again I love the building projects though it is backbreaking 

work when you are building from your own timber. 

However the porches only need small cedar logs that are 

relatively easy to handle by man power. One of the reasons 

I love building is that it is very rewarding after clearing. 

Clearing leaves scattered logs that I hate to waste. 

Building cleans up the mess and it is practically free. 

We also had to tear down a shed from another spot 

and I re-used the metal roofing and sides on the porch. 

I can not emphasize enough the need for shelter space 

when building, so porches are a real asset....especially 

these type that cost next to nothing. Building this way 

means saving what regular builders bulldoze and burn, 

so I store small timber posts and beams in these dry 

sheltered porches. Also to build creatively using some 

neat types of logs with organic curves etc...means again 

extra storage space. Keep in mind this land had nothing 

on it but woods and an old tiny house ruin when we first 

started. So the first projects were building very quick shed 

structures to store logs etc in. As I have progress the 

need has grown for more sheltered space.

Here is the shed without the front porch.

This is the shed we tore down and transported

I set the posts on raised concrete bases. Here I am using some left over cedar poles for diagonal stabilizers.
This also makes a handy place to rest the heavy beams as we raise them bit by bit.

First beam up. I like to choose one with a slight arch to take the downward stress.

In the foreground is the shed roof intact that we tore off the old shed from another place.

It was a job for my boy and myself to get up.

We used posts underneath to prop it in stages.

Then we manhandled it up and put the beam back in place. It was removed so
we could swing the roof up

About done. I only need to buy 1 12 foot sheet of metal for the last panel.

Our next post should feature our first plaster render approach. We are looking at using a compressor and gun with hopper to spit the slip layer onto the bales. My wife got burned out on the hand application method of the first layer because it involves massaging  the clay into the bale... a slow process for a small work force.

Here are some samples of the slip layer tests we did.

This is a method I am using where the bales are not quite snug enough.
I ram a piece of 2x4 between the beam and bales and then screw it into place.
It is amazing how a few extra inches of compression can make the wall really sturdy.
I only had to do this on a few spots. Consider the fact that we had nothing specifically measured for bales
when we built the post and beam frame because we were planning to use logs at that point.
Because of this some of the spaces did not fit the bales in a snug enough compression.
There are other ways around this....for instance cutting and re-tying bales.
But after the straw had sat for a year I noticed I need to add more compression in a few spots. 

Here I am getting plastic between the bale and beam where it is really
too snug to insert by hand. Using a piece of plywood and a mallet helped
push it in. Then I was able to spread it length-wise to form a canopy over the bale.